cut

  1. tesseract

    Help! How to cut Foamboard properly?

    Does anyone know how to cut foamboard properly? Whenever I cut it, it either goes off-center, the blade chips, the foam breaks, the foam pulls, and generally doesn't cut right. I have made 4 foamies before and all of them have crashed or been very draggy because of this problem. Does anyone know...
  2. stingbee

    MPCNC iin the Philippines

    hello guys, i just want to ask advices from all of you on how do you mount , and where did you connect the brushless motor with esc on the mini-rambo 1.3 arduino board? attached herewith is my pics of my mpcnc from V1 Engineering..its very difficult for me to connect all of these...
  3. K

    Brushless Motor Shakes Then...

    Okay So I Bought My Stuff From HobbyKing It Arrived Got Everything Soldered And Stuff Then I Turned On My Radio And Put Throttle To Full Plugged ESC Into The Receiver And Plugged In My Battery Then I Waited On Beeps And Set Throttle Range Then Went TO Throttle Up And Then I Had Issues Where...
  4. O

    Laser cut frames and camera gimble

    So when i first got into copters, i saw i could but all sorts of frame, but to be honest, they were boring and more importantly it was not challenge or any fun to just build a out of box frame, so i decided i would laser cut my own frames. Now i will point out, i sell these frames, but i can...