power distribution board

I have been able to fund myself for most ever other part ft sidewinder frame, motors, battery, camera, transmitter Etc. Etc. to include the original hglrc f428 fc however the pd/esc board I received does not work. So I am looking for either another f428 pd esc board or another setup to fit the...

I have been able to fund myself for most ever other part ft sidewinder frame, motors, battery, camera, transmitter Etc. Etc. to include the original hglrc f428 fc however the pd/etc board I received does not work. So I am looking for either another f428 pd esc board or another setup to fit the...

Greetings. Am looking to choose these two key components. Would like to do as little soldering as possible - for fear of destroying electronics with excess heat. Most online stores I have checked have a suprisingly small selection of these things. Can anyone recommend a good place to shop or...

Dear Flitetest forum I am currently building a scratch built quad copter. I Bought the E310 motor set from DJI (http://store.dji.com/product/e310-4) and saw in the package that there is a small power distribution board. Now I've read in the manual to solder the Wires direct on the board But...

Hi all, just bought a Q450 v3 quad frame. I solder all ESCs to the Q450 v3 power board. To check if everything is ok, I used my multimeter in transistor mode and: - 1st, + with + Result: Started with a value that reached 0 after a few seconds (common behavior when connectivity...