It seems I posted this elsewhere in the wrong place.....
Anybody with experience in APM Tri copters? I'm sure this has been asked before, but I really need to get this thing off the ground.
I'm set to go except one thing. My Tri Copter has no yaw servo movement. The signal seems to have no pass through. The motors spin up with the throttle, and adjust in different attitudes, but no tail servo. I have no where to begin, and need suggestions.
It has power supplied from a separate step-down converter to the tail servo, and retracts. I am running an FRSKY module in a futaba 9C with a FRSKY D8R-XP in CPPM mode.
The radio calibrates, and all the green bars move through Ch 8, here are no warnings at all.
Is there a way to check the firmware while connected to make sure it is tri copter firmware?
It seems that when you select the frame type in MP, the tri copter frame is mixed with a whole bunch of others kind of generally...
I am suspecting that the tri copter firmware is not going into my board, which might explain no tail servo movement. (maybe)
Any suggestions?
Thanks
Ted
Anybody with experience in APM Tri copters? I'm sure this has been asked before, but I really need to get this thing off the ground.
I'm set to go except one thing. My Tri Copter has no yaw servo movement. The signal seems to have no pass through. The motors spin up with the throttle, and adjust in different attitudes, but no tail servo. I have no where to begin, and need suggestions.
It has power supplied from a separate step-down converter to the tail servo, and retracts. I am running an FRSKY module in a futaba 9C with a FRSKY D8R-XP in CPPM mode.
The radio calibrates, and all the green bars move through Ch 8, here are no warnings at all.
Is there a way to check the firmware while connected to make sure it is tri copter firmware?
It seems that when you select the frame type in MP, the tri copter frame is mixed with a whole bunch of others kind of generally...
I am suspecting that the tri copter firmware is not going into my board, which might explain no tail servo movement. (maybe)
Any suggestions?
Thanks
Ted
