servo mounting

I was wondering if I could use a smaller propeller say a 7x5 on a big motor like a 2218 which can handle a 10x4.5 prop. Also, I was wondering if there was a way to install servoes in my scratch build without using hot glue because it rips off the paper if I try to remove it to use in another...

Servo Mount 9g Double STL Designed By: Dan Sponholz 3D printed double servo mount for use with most 9g servos. Makes servo replacement easy and convenient using the included servo mounting screws. Print Settings: Material: PLA+ (eSun) Layer Height: 0.20mm Supports: None Rafts...

Servo Mount 9g Single STL Designed By: Dan Sponholz 3D printed single servo mount for use with most 9g servos. Makes servo replacement easy and convenient using the included servo mounting screws. Print Settings: Material: PLA+ (eSun) Layer Height: 0.20mm Supports: None Rafts...

I’m going to put ailerons on my UMX Radian (micro). Here’s the deal: I want to connect a new servo and wires to control ailerons (servo arms counter rotating the wires). Wires will have to bend around at least a few pivots before reaching the horn. I will order new foam wing and cut ailerons...

So I'm kinda close to completion on my FT Storch wing (this is my first go at building). I'm now at the step of connecting the pushrods to the servos. My servos are the ones that came with the Power Pack B, whatever model servo that is. The build video has been great but Josh glosses over...

Ok, it happened a second time! I glued in a servo only to find it totally frozen. Actually it was fried, baked, cooked, or somehow melted inside by the glue. I applied a sparing dot, but that was still too much heat for this tiny servo. My plane is a Sparrow, and after a number of crashes...