tilt

Hello people, I thought I’d share my DIY Pan and Tilt mount in case anyone else wanted a micro setup. Using two old servos, some servo arms and hot glue she works surprisingly well! I used thread locker on the screws that hold the camera itself so they will not (or should not) come lose.

I have a wizard x220 betaflight 3.1.1 and have activated servo_tilt but inorder for that to work I need to remap my output pins in the cli using "resource" but when I type in "resource" it just lists the resources and if I type a command for example: "resource MOTOR 5 none" or "resource SERVO 1...

Hello Flite Test, and Hello fellow prop heads! What I want to do is make a Quad layout of 4 motors, around 250mm to 300mm apart from each other (X configuration). Each motor will be mounted on/tilted by a servo, and they will move by the following rules: Plane mode: Front motors pull the rear...

I am having problems with my first tricopter build. I purchased the Dragonfly and I have it put together. Unfortunately every time I give it throttle, the whole copter spins. The tough-tilt keeps pitching to the right. Does anyone know what I can do to fix this?

Hello all, I have an interesting issue where i'd like to use the gimbal mode, but ONLY for the pitch. I have read through sever areas where folks turn on the servo gimbal mode but that moves the four motor controls to slots 3,4,5, and 6. Currently 6 is connected to the OSD on the power and...

Right, so I am posting this about my latest tricopter build, based loosely off the great Windestål's design. Firstly I will say that I am 15, live in the UK, and am currently having my summer holiday. This build was completed to a massive budget, and in my mind was mostly an upgrade. I know this...

If you're looking for a quick and cheap way to build a tilt mechanism for your tricopter, here's one that I came up with that might interest you... https://www.youtube.com/watch?v=KZerXxwRcrg hope this helps! -jeff

Hi guys, in the last few month, i built three quadcopter with kk2 boards. 1 x V-tail (30,5 cm arm length, like simplecopter.com) with sunnysky 2212-980kv @ SF 10x4.5 1 x Spider with motorspan 36cm with Turnigy D2830/11 1000kv @ SF 10x4.5 1 x Quad x with motorspan 24cm with Turnigy DD2822/14...

Hi, Are the CAD plans available for the batbone series yet? I'd like to look into adapting them for DT750's (as per David's original Tricopter design) I could start designing from scratch again but would like to make it swapable with people who already have pieces. Also incorporate a V-Tail...