3A UBEC Module Bluesky

[Bonards]

Hi guys.

I intend to build an small glider, I'm thinking about a mini DLG like the BUG or MiMi, for this I bought a small 2S 300mah Lipo and a small receiver, and to build it lighter as possible I bought a 3A UBEC Module Low Ripple Bluesky Mini Switch-Mode DC BEC 5V 12V 2-6S Supply from banggood ( http://www.banggood.com/3A-UBEC-Mod...-Mode-DC-BEC-5V-12V-2-6S-Supply-p-993056.html ). The problem is, where should I solder the positive and the negative wires from the battery and to the receiver?



I know that the IN is for the battery plug wires and the OUT is for the receiver, but it has no + ou - signals.

Someone can help me in this?

 

[ztoon]

Hi,
GND is negative (both sides)
IN is positive (to battery)
OUT is positive (to Rx)
You can go even lighter using a 1S battery (no BEC) if your Rx accept it. Try and test on the workbench before flying.