3D Print Tenet; Nose

[alan0043]

Hi Everyone,

I have a question or too about the 3D print Tenet nose. It looks like the nose is held in place using 2 magnets. The magnets size looks to be 3/8" dia. If I am wrong about the size, please let me know. I have done a search for the magnets but I not find what can work. I can find magnets but no magnets with a steel receiver piece that is the same size as the magnet. Were did you find your magnets ? I have looked at Home Depot and some of the big box stores. Please point me in the right direction.

Thank you for any help,
Al

 

[Kzhurley]

I haven built one but I would think you would just use another magnet instead of steel for the receiver side

 

[txrocks]

What did you use for wings on your 3D printed Tenet ? I am printing the parts now and was going to start building the wings. I have the foam board. I did not buy the wings from FT.