3D Printable Steerable Nose Gear 1

[johnbecker31]

johnbecker31 submitted a new resource:

3D Printable Steerable Nose Gear - 3D Printable Steerable Nose Gear

This is a 3D printable, steerable nose gear, that is also modular in the way that it can be removed from the aircraft and replaced without damage to the airframe.

Print with 100% infill, and without the need for support.

uses 2.5mm music wire for the gear wire.
uses 3 wheel collars which can be purchased from amazon.
Amazon: Wheel Collars

Read more about this resource...

 

[tomlogan1]

johnbecker31 submitted a new resource:

3D Printable Steerable Nose Gear - 3D Printable Steerable Nose Gear



Read more about this resource...

OK You have provide me with the Quickie, now nose landing gear! If you could just send along a few 4s batteries!🤣

 

[Scotto]

I looked everywhere for this just a couple weeks ago! The design I came up with looks very different. Yours looks easier and lighter... Thanks for sharing

 

[johnbecker31]

OK You have provide me with the Quickie, now nose landing gear! If you could just send along a few 4s batteries!🤣

well, I can certainly CAD some up, but unfortunately, I have not found a way to 3D print batteries. but when I do, I think I will be retiring!

 

[skymaster]

so how would you install it and on what plane?

 

[johnbecker31]

so how would you install it and on what plane?

it is just a generic nose gear that can be adapted for man models. I tweaked it and adapted it for the Retro Rocket. works great!

 

[skymaster]

would you mind if i molded your design see what you think?