kentbenson
New member
Hi all,
I've been flying my fpv quad for the past few months and want to add a servo to the build. I saw another thread saying you could use a tx pad to send a signal to a servo so I've been trying to do that. I've remapped it in the CLI to be a servo, I've checked "SERVO_TILT " in the config tab, and have also set up a signal on my aux 4 which betaflight shows is working. It's still not working so I'm sure I'm missing a step. Thanks for any help you can provide!
Thanks in advance for your answer.
192.168.0.1 routerlogin 192.168.10.1
I've been flying my fpv quad for the past few months and want to add a servo to the build. I saw another thread saying you could use a tx pad to send a signal to a servo so I've been trying to do that. I've remapped it in the CLI to be a servo, I've checked "SERVO_TILT " in the config tab, and have also set up a signal on my aux 4 which betaflight shows is working. It's still not working so I'm sure I'm missing a step. Thanks for any help you can provide!
Thanks in advance for your answer.
192.168.0.1 routerlogin 192.168.10.1
Last edited:
