applekeith
Junior Member
This is an odd one. And I am at my wits end... In Beta Flight I can use the program to move all of the motors, nice in sync or individually. If I use the transmitter, motor 3 may get half way compared to the other 3 maxing out at 2000. I have tried multiple versions of betaflight. If I swap motors 3 and 4 on the FC (NAZE32), motor 3 still is not as responsive. I have calibrated the ESCs numerous times (no help). I replaced the PDB. Replaced the FC, and receiver (OrangeTX/RX) as well.
I don't know where to go from here. Everything looks good in betaflight. The receiver/transmitter work like they are supposed to. It is only motor 3.... Like I said, I am at the end of my rope and about ready to chuck it all out. As a side note, I started with cleanflight and it does the same thing there. I would suspect the FC, but not two of them for the same thing. But I do have a third...
Any hints, suggestions, thoughts will be appreciated. I attached some screen caps of the transmitter/rx page and the motors page...
Keith
I don't know where to go from here. Everything looks good in betaflight. The receiver/transmitter work like they are supposed to. It is only motor 3.... Like I said, I am at the end of my rope and about ready to chuck it all out. As a side note, I started with cleanflight and it does the same thing there. I would suspect the FC, but not two of them for the same thing. But I do have a third...
Any hints, suggestions, thoughts will be appreciated. I attached some screen caps of the transmitter/rx page and the motors page...
Keith