Hello!
I don't know what i did in software or programming (i didn't to anything obvious) but now, after arming the nanowii board, the motors go to 1 (from 1080 default when not armed) and only go to ~1300 when at full throttle.
I can't arm the board with stick movement, so i programmed the startup on the channel 5 (so i have to enter the config interface).
Has anyone encounter this?
Any ideas on what to do to repair it?
I don't know what i did in software or programming (i didn't to anything obvious) but now, after arming the nanowii board, the motors go to 1 (from 1080 default when not armed) and only go to ~1300 when at full throttle.
I can't arm the board with stick movement, so i programmed the startup on the channel 5 (so i have to enter the config interface).
Has anyone encounter this?
Any ideas on what to do to repair it?
