My son is slowing moving into rc flying.
So it was time to put my knowledge to work and build a high wing trainer.
Meet the J1.
Details:
2" at the widest (nose)
5" at the tallest point
36" from spinner to elevator end.
Will do. 50" wing (fits in the trunk).
1000 KVM D2830 Turnigy
35A HK ESC
10x6 Prop
Skis
Should fly well but won't know till the weekend.
I am closely following the Cub design but taking some creative twists.
Narrow, but double walled in sections, poster board on the section sections (top and bottom)
Used the FT Spitfire tail section but modified to have a full elevator.
Right now all the servos will be setup with slow #2 throws since it is a trainer.
Hoping this works out and I also get a nice winter plane as well
A.
So it was time to put my knowledge to work and build a high wing trainer.
Meet the J1.
Details:
2" at the widest (nose)
5" at the tallest point
36" from spinner to elevator end.
Will do. 50" wing (fits in the trunk).
1000 KVM D2830 Turnigy
35A HK ESC
10x6 Prop
Skis
Should fly well but won't know till the weekend.
I am closely following the Cub design but taking some creative twists.
Narrow, but double walled in sections, poster board on the section sections (top and bottom)
Used the FT Spitfire tail section but modified to have a full elevator.
Right now all the servos will be setup with slow #2 throws since it is a trainer.
Hoping this works out and I also get a nice winter plane as well
A.