inav

  1. L

    Trouble updating Speedy Bee F405 wing Flight Controller

    I have been having trouble upgrading firmware in 2 Speedy Bee F405 Wing Mini and 1 Speedy Bee F405 Wing APP Flight Controllers. They were not being opened in DFU mode. This was true in INAV and in Betaflight. I finally solved the issue. I had to open ZADIG Zadig 2.9.788 to install USB drivers...
  2. B

    My FPV journey takes a big step forward! FPV for beginners and my new FPV adventure. Part 3.

    One small step for man maybe, but here's part 3 of my continuing journey into FPV, including two fails in my trips to the flying strip, and sorting the problems afterwards. But (spoiler alert) after a couple of weeks of hard learning I found it fascinating to be able to flick a switch on my...
  3. S

    Help! Throttle Not Accurately Tracking

    Hello, I am having this issue where my throttle in iNavFlight and my blackbox is not tracking properly. The throttle in the blackbox (RC Command) is tracking lower than what the reciever tab is recieving in iNav reciever tab. Originally iNavFlight recieved a range of 987-2011, i applied a 98%...
  4. BayDesigns

    FPV Camera Pan/Tilt

    I really have too many ideas running around my head... oh well. I’m planning on building a removable camera pod to be placed on the bottom of an airplane, with pan and tilt. I’m considering using a low-light/IR camera, so an IR illuminator may be included. Regardless, the design will probably be...
  5. A

    Help! Ómnibus F4 Pro to GPS and FrSky R9mm

    So I’m building a quad, and have gotten a Bn-880 and FrSky R9 mm. I was hoping someone could help connect the R9 mm to my Omnibus F4 Pro. I connected the GPS to UART 3/6 on J10 so that’s gone, and I was planning to connect the Sbus, Ground, and 5V to J7 on the Pinout, but where would I connect...
  6. CapnBry

    Ridge Runner motor glider soaring adventure

    I've always wanted to fly an RC plane. When I was a kid, my dad and I would build models together from plastic kits to balsa and tissue rubber band flyers up to a control line 0.049 piper cub. Our builds always went incredibly slow, partially due to my father's meticulous attention to detail and...