interference

Hi, just want to share an issue I'm having, hope somebody knows how to solve it. I was just calibrating my ESCs throttle to get them in sync on a quad powered by a KK2, but instead of the two beeps at full throttle and then one beep at idle, after the usual ''1+4 button, power up, wait for...

Hey all, I have an entry level quadcopter that operates on a 2.4GHz control frequency. I wish to fit my wifi action camera and then fly FPV off my phone. Has anyone experienced problems with controlling their quadcopter while using a wifi camera i.e. losing control of the quad due to wifi...

Hi guys, i need some help. I am fairly new to the hobby, flying my second plain, Ft Trainer. My first was the FT Flyer and i had no problems. Flew like a dream and got a lot of experience. My second plane, the FT trainer flew just fine too until here lately. I was flying in the park and my...

I have a 2.4GHz FrSky transmitter and receiver combo and a 915MHz telemetry module from 3DR. After plugging in the telemetry module, I noticed a twitch in the tail servo on my Tricopter. It twitches every 1 second or so in a little pattern. like T-T-T--T--T-T-T--T... T stands for twitch, wasn't...

I have strong neodymium magnets that I was planning to use on hatch covers and the like. Will that mess with my electronics? If so, where's the best place to install some ferrite rings?

My story begins when I began to notice some very poor performance from my MacBook Pro. The internet connection seemed to slow to a stop now and then. I tried all the simple things like virus scans and rebooting the router to no avail. But then one day, I was messing around with my Turnigy 9x...

So I got the Orangerx openlrs 100mw rx and module a few weeks back. I uploaded the openlrsng firmware sucessfully. They worked perfectly for about 10 flights, until randomly they just stopped communicating. I had no servo control and every time I would plug the battery in the servos would start...