maker foam

I'm building a Mighty Mini Old Fogey but have found that the Maker Foam kit parts have shrunk so that edges are now a U-shaped groove instead of a flat cut (see pictures). (The parts have been stored and handled in normal temperature and moisture conditions.) This shrinkage causes two problems...

(Disclaimer: I do not know for sure that Maker Foam v2 will be a reality.) Hey guys just wanted to start a discussion about FT WR Foam Board and the possibility of Maker Foam v2 (or something similar) being released soon! So the FT brown water resistant foam boards (25 and 50 ct. boxes) are...

I’ve been holding off on getting a few of the master series SBK’s for a while now and since there were no sales this past week I’m going to buy a few, but less than I was planning before. My question to everyone out there with experience, would I be better off getting the brown foam version...

FT Guinea Pig Designed By: Peter Sripol Plans By: Dan Sponholz Description: The Flite Test Guinea Pig is the perfect platform to carry out the craziest experiments in the air. While it can carry a hefty payload, which can be dropped out the rear hatch, it can also be set up to carry out...