100 mm build

Zaid1221

New member
Hey Everyone I finally decided I want to do a 100mm build. Since this is my first build I am not to sure what parts to pick or what parts are compatible. So I did some research and found these parts.

Frame- https://armattanproductions.com/pages/kit_detail/3842

Vtx/camera- https://www.banggood.com/RunCam-Mic...H-AV-VTX-Transmitter-FPV-Combo-p-1164455.html

ESC- SPEDIX 30A 4 IN 1 ESC

Flight controller- RJXHOBBY SP Racing F3 Flight Controller

Motor- DYS BX1306 1306 4000KV

I will be soldering a xt30 connector to the flight board. I already have a pair of goggles and a fly sky FS-i6 radio. I want to make this quad for 2s-4s capability. Please let me know if something is not compatible or if I am over paying, under paying for some parts. Thanks in advance for the help!
 

ageorge

New member
hi there,,,everthing looks good i think for the price.However i would not really put a 4in1 esc in any of my builds.Reason being is that if something happens to it it is a lot more expensive to buy a new one ,rather than replace just one individual esc.Also i dont really think u would require an esc as high as 30a.I checked the motor specs and the max amp draw on a 3s with a 3045 prop is 7.7amp so u could go with a cheaper less powerfull esc eg maybe a 12a would do just fine as even on 4s the max power draw is 10.7amp.
 

French

Construire Voler S'écraser Répéter
Zaid, welcome to flitetest! Your link on armattan isn't showing a specific frame. Which one are you looking at?
I ask because most micro frames in the 100mm range use 20x20mm stacks. The other components you have listed are full sized (30.5 x 30.5 mm)

I wouldn't worry too much about a 4-in-1 esc from speedix. Low quality escs can definitely be a gamble, but in my opinion, speedix provides a great product. I don't see any way a 1306 could stress a 30A esc.

Lastly, if you're set on the SP Racing F3 board, it doesn't come with the newer betaflight OSD that many newer boards have now. While an OSD is not necessary, I'd suggest picking up a new RunCam swift micro 2 that has the built in OSD for battery voltage and on time. The micro swift you linked above is the version 1. That VTX is good.
 
Last edited: