• This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn more.

A-10 Plans problems

#1
when I print out and tape the plans together the wing span is only 42" instead of the 60" the cover sheet shows. did some thing not print I have a right and left wing and wing center. has any one tried to print these plans
 
#4
I printed out 100+ sheets cut all parts out taped tougher transferred to foam board looked small so measured it. wing and center sections were 14.5 in ea. cant figure out where I went wrong
 

The Hangar

Well-known member
#6
There are two different sizes of tiled plans - tiled A and tiled B. The tiled B are for printing on 10.5x15 while the tiled A are for printing on standard printing paper. If you printed the tiled B on normal printer paper it would make sense that the wingspan would be smaller.
1586380042120.png