Anyone smart with OpenTX? Trying to bind a RadioLink R8EF rx

[trey]

According to this page, the radiolink r8ef will work, but I need protocol 74. I can't figure out what protocol 74 is, and I only have protocol names. Any thoughts?

https://www.multi-module.org/using-the-module/protocol-details/radiolink

 

[trey]

I needed to update my multimodule 🤦🏻‍♂️

 

[Bricks]

I needed to update my multimodule 🤦🏻‍♂️

I was just going to say ^^^ you should up date the radio software at the same time.

 

[trey]

I was just going to say ^^^ you should up date the radio software at the same time.

Doh. It binds, but no movement at servos. I think I need to remap channels, but I can't figure that out yet. There's specifics for failsafe listed.

 

[Bricks]

Doh. It binds, but no movement at servos. I think I need to remap channels, but I can't figure that out yet. There's specifics for failsafe listed.

Once a servo is plugged into any port of 1-4 should move the servos has nothing to do with mapping the servos. May not be correct servo movements for each channel but they should work no matter what. Are you sure you got a good bind?

 

[trey]

Once a servo is plugged into any port of 1-4 should move the servos has nothing to do with mapping the servos. May not be correct servo movements for each channel but they should work no matter what. Are you sure you got a good bind?

Pretty sure. Solid bind light, and I did fine tuning.

 

[trey]

I think I need to clear the throttle zero warning first. That's probably it.

 

[trey]

I think I need to clear the throttle zero warning first. That's probably it.

That was it. Thanks for the help!