Balancing NUTBALL??

[RogerRamjet]

This is a re-post to the correct Forum ??


I've just built a Nutball swapable its weighing in at about 230grams without the battery (24gram motor).

I seem to need a lot of weight up front to balance it even with a battery (850mA 2 cell)

I've got a slightly larger motor (about 40 grams) I could use would this be a good idea?

I'm using CoG point at 5 inches from front ply former.

Any suggestions or helpful comments??

Thanks

 

[Estoll]

On my nutball i was using the Suppo 2208/14 1450kv motor it weighs 36 grams and with a 2200Mah 3 cell it had plenty of power with a 8x3.8 and balanced nicely same with the flyer.
Hope i helped!

 

[Estoll]

To clarify i would recommend either changing to a 3 cell or get a larger Mah battery depending on your setup. Also i forgot i have nose weight on my setup even with how heavy it already is to get it to balance.