I'm building my first 250 quad and these's are my parts.
Tx - Spectrum DX6i
Frame - Emax 250 (I think... looks the same)
PDB - CC3D Power Distribution Board With 3A BEC Output 5V 12V
ESC - ZTW Spider Series 12A OPTO Multi-Rotor ESC 2~4S (SimonK Firmware)
Motors - Eachine BG1806 1806 2300KV Brushless Motor 2-3S
Props - Genfen 5030
FC - CC3D EVO
RX - 2.4G 6CH S603 Receiver Supported JR Spektrum DSM-X DSM2 Transmitter
FPV - Eachine CCD 700tvl 148 Degree Camera Lens w/ 5.8G 200mW FPV Transmitter
Lipo - ZOP Power 11.1V 1500mAh 30C Lipo Battery XT60 Plug
I noticed my ESC don't have BEC so Im going to power the FC from the 5V BEC connection on my PDB.
The FPV Tx will be tapped into the same 5V BEC connector. The PDB 5V BEC is rated up to 3A and my FC + FPV Tx
combined draws less than 1A.
Any Advice on what I've got or should look at swapping out.
I may change out my lipo once I've seen how it preforms on the quad.
Thanks.
Tx - Spectrum DX6i
Frame - Emax 250 (I think... looks the same)
PDB - CC3D Power Distribution Board With 3A BEC Output 5V 12V
ESC - ZTW Spider Series 12A OPTO Multi-Rotor ESC 2~4S (SimonK Firmware)
Motors - Eachine BG1806 1806 2300KV Brushless Motor 2-3S
Props - Genfen 5030
FC - CC3D EVO
RX - 2.4G 6CH S603 Receiver Supported JR Spektrum DSM-X DSM2 Transmitter
FPV - Eachine CCD 700tvl 148 Degree Camera Lens w/ 5.8G 200mW FPV Transmitter
Lipo - ZOP Power 11.1V 1500mAh 30C Lipo Battery XT60 Plug
I noticed my ESC don't have BEC so Im going to power the FC from the 5V BEC connection on my PDB.
The FPV Tx will be tapped into the same 5V BEC connector. The PDB 5V BEC is rated up to 3A and my FC + FPV Tx
combined draws less than 1A.
Any Advice on what I've got or should look at swapping out.
I may change out my lipo once I've seen how it preforms on the quad.
Thanks.