• This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn more.

FT Unlimited Racers - Balistix parts

#1
Yo people, stoked on these. Started off with FT racer plans, but lots changed by the end....

One is essentialy ripslingeresque, and the other I called an Air Grabber.

Both run on 4s - 650kv with 13x6 and 12x6 props. They absolutely rip ! Super fun to race !

3D printed Motor Mounts, and tail wheel assemblies


0127151642b.jpg 0127151641e.jpg 0127151641d.jpg 0125151241a.jpg 0120151516a.jpg 0120151516c.jpg 0118150929.jpg 0118150929a.jpg 0118150930.jpg
 
#2
Very nice, did you cover them with packing tape?

If it looks like packing tape and smells like packing tape it probably is packing tape
 
#4
Thank you !

Duct Tape, Masking tape, and artist tape.....lots of glue hahaha

not sure on the speed. I guessing 75-80 mph. I have the little 50mm EDF jets. They do like 50+, and these make the jets look like they arent moving....
 

jayz 84

Posted a thousand or more times
#5
That gives the racer a whole new look. I like it nice job. They would deff need more power to excite me tho. But great job man. It gave me some ideas
 

jayz 84

Posted a thousand or more times
#7
not sure on the speed. I guessing 75-80 mph. I have the little 50mm EDF jets. They do like 50+, and these make the jets look like they arent moving....
Well looking up your motor specs. With the power setup you are running. Kv x pitch x volts. Is giving you a pitch speed of only 60s. Now mins drag and other aerodynamic characteristics of your build. your only looking at a top speed in the 50mph range. You need a motor with a bit higher kv and watts..