Solved P-40 power pack C issue.

Hi all! I just finished putting together my new P-40 with the Power Pack C and was wondering how to install the prop correctly. Where the power cell slides into the nose, it leaves very little prop clearance between it and the nose. The spacers included didn't seem to be enough, with only the two large ones fitting the radial motor. This is my very first diy rc build and everything else came along nicely. I'm just stumped. Any suggestions?

Here it is.


  • 15902922441205939255244150513684.jpg
    1.1 MB · Views: 0

luke k

Active member
so in the kit i bet you can just extend it and glue it and put the bbq sticks through it. if that helps
I figured it out. I didn't use the little X spacer that comes with the motor. Lol I put it on and the problem was solved. I feel like such a noob haha