I'm in desperate need of help.
Tried to maiden again the P40. This time it went a little bit better. It was airborne for about 20 seconds but every time I let back the elevator it gone directly to mather earth, nose first. As long as I hold on the elevator it went flite but almost verically up....
I'm using this motor:
#Aliexpress RON 16.07 9%OFF | JMT A2217 950KV 1250KV 1500KV 2300KV Outrunner Brushless Motor 3-4S For RC Airplane Aircraft DIY Drone 6/7/8/9/10/11inch Props
https://a.aliexpress.com/_dStSM2N
1250KV. Dose it have enough power for this airframe?
Again the CG was in the point my finger is in the picture. Is it OK?
Now the airframe is completely compromised. I will buy again some foam board and completely rebuild it.
Please help what should I do to get it airborne....