ez series

  1. SP0NZ

    Plane EZ Intruder 15 1.0

    EZ Intruder 15 Design by: Dan Sponholz The EZ Intruder design is inspired by the Air Hogs Intruder circa 2001. The Intruder was developed by Spin Master Toys, and sold under the Air Hogs and E Chargers brands back in 2001. Later in 2003 it was rebranded as the Resistor with 2 new liveries...
  2. AgentC

    Plane EZ Sparrow 1.1

    Based on the FT Sparrow, but designed for the EZ series: Above GIF: My twin flying for the first time Notes: Plans are Tiled 8.5x11", print them at 100% as per the ususal FT style. PROP NOTE: This plane has the props facing forward, so swap the props and reverse them (ie. put the left...
  3. FoamyDM

    Plane EZ Viking S3b by FoamyDM 1.1

    FoamyDM's EZ-Viking S3b Yard flyer While building a MS large park size build of this model, I wanted to see if I make a quicker version of this Labor of love, to check CG and have some fun. (glide test model) (see below on the progress shot of the bigger version) The EZ-Viking S3b weighs 40g...
  4. GrizWiz

    Skin EZ Raptor Skins V1

    EZ 3 channel Pack powered F-22 Raptor. Designed for 3 channel EZ Power Pack, but 2 channel pack will work too. Plans: Here Peel paper from the foam and use spray adhesive to secure the skin. Coming Soon: Build thread
  5. AgentC

    Plane EZ Bronco 1.5

    OV-10 Bronco! This works with both the 2-channel and the 3-channel power packs. The turning radius and flight response is much tighter with the 3-channel, naturally. Wingspan:14" Foam Board Weight: Approx. 20g Total weight with 3-channel parts: Approx. 50g Original Maiden: Version 1.5 Full...