pod

  1. fliteadmin

    Part FPV Pod for the FliteTest Grumman G-44 Widgeon 1.0

    Take your Flite Test Widgeon flying experience to the next level with this 3D printed FPV pod. Its design allows for airflow to cool the camera and video transmitter during flight while preventing water splashes from damaging the equipment during takeoffs and landings on the water. Print the...
  2. fliteadmin

    Part micro RunCam Split 3D Pod 1.0

    This is a Micro RunCam Split enclosure that fits the aesthetics of the FliteTest Dart and the Sparrow. It houses a full micro RunCam Split and a VTX and gives you the capability of being able to swap it out in different planes without re-soldering anything. Click the download button on...
  3. T

    Tiny trainer with motor Pod- Will it fly?

    I really liked the idea of the high mount motor used by trainers like the Crash Test Hobbies Albatross. So I put one on a Tiny Trainer with glider nose. pointed slightly to the left. It balanced out ok on the plan CG with the battery and electronics as far forwards as possible. Will it...
  4. D

    New Trainer Swappable

    I built a Versa Wing and decided that I wanted something slower and more stable for helping others get started in RC. I had flown balsa trainers when I learned to fly 30 yrs ago and thought that might be a good way to go. Here is my Versa Wing and power pod. I then downloaded a profile view...
  5. Maingear

    Kraken Keel Fairing

    I wanted to finish off the belly of my kraken and here's what I came up with... I didn't want to fuss with tools for any fasteners so I slapped another paint stick on top. Drilled 1/8" holes so I could hot glue bungie cord secure. The cord will conform to whatever shape, I can make changes...
  6. T

    T28 to Swappable Pod landing gear conversion

    Pictured above is my idea for landing gear that was derived from a quick modification to some ParkZone T28 gear I had sitting around. (To the left is my beater gear that never actually works) I needed some more robust landing gear than the rubber band and bent wire but I wasn't about to pay $15...
  7. T

    Versa pusher Power Pod adaptor

    === OP start === I am building a simple 15cm wide center section for the versa wing that will allow the placement of the power pod in either direction without changes to the pod or airframe in order to make it truly swappable. When I am done I will make plans available and submit an article...
  8. B

    Add pusher power Pod to Simple Soarer

    I am about to build a SS as project to entertain me as I recover from should replacement surgery. I plan on using it as both a tow launch and power glider. That said, I am toying with the idea of adding a power pod above and just aft of the wings. Something similar to the Bixler (II). So...