rates

I'm planning on having the maiden flight of my newly built master series an-2, and was wondering if anyone has any tips or knowledge on how they fly? What rates should I have, should I set expo, any bad flight characteristics, is the suggested CG good, how fast does it fly? etc. Hope these...

Hey all, I recently got into a debate on control horn setup. I was under the impression that having the push rod in the top/highest slot in the control horn would give the most throw, and moving it down the control horn would decrease the throw. However, when I sat down and looked at it, if...

I'm a bit of a newbie and i'm having some issues with my taranis i recently picked up. It works perfectly in simulators, its bound correctly to a frsky xm+(atleast the steady green light is showing), but rates are not shown in cleanflight. In cleanflight i've set Reciver to serial-based reciver...

I have been flying my Versacopter for some time now and upgraded to the new mounts. I use powerpack E and a 3 cell battery. It flies pretty well and I fly a lot in acro mode now. Sometimes I get some oscillation when I cut the throttle when lowering altitude and I cut the throttle too much. My...

I have a Spektrum tx and rx and am looking for some guidance as to throw rates, expo, and mixing for the upcoming maiden flight of my AXN Cloud Jet. I have the aileron control rods in the horn slot closest to the wing (max throw) and the rudder and elevator control rods in the middle horn slot...

Hello interwebiverse! I have tried to get into multirotors for about nine months now. I started off with a tricopter that was a blast. However, I started having a couple of FC problems and ended up with a Flip 1.5. I had trouble with the tri-configuration, so I converted it into a quad. It...

Is the new Sukhoi 29mm by Parkzone the next step forward in learning 3D? I've bought one because it was simply irresistible. I hope that I made a good decision. Using a Spektrum DX6i some good advice might be that it seems that the critical thing is to RESET the Model #, don't leave any...

Today I was intending to maiden the scratch build of the FT-3D. It was a normal day, but it turned out to be my worse flying day out of my 'career'. I had strayed from the recommending build, deciding to use a smaller propeller, .0947EF prop, than the recommending 1200kv motor. I only have the...