vontugboat
Junior Member
I am not good at bending steel wire to make landing gear So I drew up some landing gear legs in Sketchup and printed legs for my Storch; they're plenty sturdy and only about 30g heavier than the steel gear setup.
For those interested in printing a set for themselves, I've posted the files on YouMagine under a non-commercial license.
https://www.youmagine.com/designs/landing-gear-for-flitetest-storch
My print settings: 0.3mm layer height, 20% infill, 1mm wall thickness. Definitely use a brim!!!! Support is not necessary.
For those interested in printing a set for themselves, I've posted the files on YouMagine under a non-commercial license.
https://www.youmagine.com/designs/landing-gear-for-flitetest-storch
My print settings: 0.3mm layer height, 20% infill, 1mm wall thickness. Definitely use a brim!!!! Support is not necessary.