qwijibo
Active member
Just thought I'd share my newest project, the 3D labs Spitfire. Only have the wing done so far.
So far it's been printing great though. Had some warping and bed adhesion issues, but upped the bed temp to 72 and it all went away. I'm not using paint or anything, just pausing the print at specific heights and changing out the filament. I measured wrong as indicated by the thicker white stripe on the outside....but it's not worth re-printing just for that.
It's coming out so nice, I'm going to be terrified to actually fly it! I know they say the glue joints are plenty strong, but it sure makes me nervous.
So far it's been printing great though. Had some warping and bed adhesion issues, but upped the bed temp to 72 and it all went away. I'm not using paint or anything, just pausing the print at specific heights and changing out the filament. I measured wrong as indicated by the thicker white stripe on the outside....but it's not worth re-printing just for that.
It's coming out so nice, I'm going to be terrified to actually fly it! I know they say the glue joints are plenty strong, but it sure makes me nervous.
Last edited: