On my recently built Gremlin, everything looks to be set up ok but is there any reason why my quad can arm when not connected to with USB but is not reflected when connected to BF? The ARM setting doesn't light up when the tick mark is in the active range. In CLI, the two arming flags that are shown are CLI and MSP. Since both of those are present when the quad is connected by USB and you're in the CLI screen, is there no way to show the quad is armed in the Modes tab unless I'm disconnected from the configurator?
.
Oh and the other little bump I run into is BF doesn't reboot successfully. I have to click "Connect" again. When I do a reboot, it shows the serial port was not successfully closed. Sometimes when I click "Connect" after first plugging in, it grinds away for a minute and nothing happens. But when I click "Connect" it again, it connects. Is this a bug in the software, or something funky with the EMAX Femto SP Racing F3 EVO FC?
.
Oh and the other little bump I run into is BF doesn't reboot successfully. I have to click "Connect" again. When I do a reboot, it shows the serial port was not successfully closed. Sometimes when I click "Connect" after first plugging in, it grinds away for a minute and nothing happens. But when I click "Connect" it again, it connects. Is this a bug in the software, or something funky with the EMAX Femto SP Racing F3 EVO FC?