Bloody Wonder CG

[ofiesens2]

I am currently in the act of preparing for my Bloody Wonder scratch build, and as I laid the plans out to see if I missed anything, I noticed that there was no CG mark anywhere. I figured it might have been the printer's fault (the score line on the spar did not fully print), but when I went to the online PDF to check out the plans, I didn't see a CG mark there either. Am I completely missing something? If not, could someone who has a dialed in BW please let me know where the CG should be? I am running the 24 gram motor with an 800mah 3s if that makes any difference.

Also, does the dotted red line on the plans mean make a 50% score cut on the other side of the foam, or does it not matter?

 

[stay-fun]

On the plans I downloaded, there is this circle with an "X" in it, on the wing plans. That's where the CG should be.

 

[510thousandths]

about 3/4 of an inch behind the back edge of the spar.

 

[ofiesens2]

Stay-fun, that's what I was missing. On the SBKs I have gotten from FT, I had those, but the plans I printed didn't.

Thanks 0.510. Just to make sure, this is on the V2 right?

 

[KishMot]

I balance it at the aileron servo.