Can anyone help me understand this?
I have the radiolink AT10 Tx. I'm using the the r10D Rx .
I hooked this Camera designed for the Tiny Whoop directly into the receiver. Hooked a 2S battery in, I smoked up my 12A ESC BL Heli (came with the emax 1806 2280kV motors), after only 1 test of the system. and nearly did it again to the next ESC. It was causing the Rx to "brown-out" I suspect - as when the camera was plugged in the "all powered up" LED stopped glowing.
After looking at the specs on the camera (2.9-5.5V Power with 215mA draw) compared with the reciever, 5V 36-48 mA I think I might have the culprit. Except... I had an EF-01 with a 360mA draw hooked in the same way and never had an issue...
I used the setup today without the camera and had no overheating issues.
What gives?
I have the radiolink AT10 Tx. I'm using the the r10D Rx .
I hooked this Camera designed for the Tiny Whoop directly into the receiver. Hooked a 2S battery in, I smoked up my 12A ESC BL Heli (came with the emax 1806 2280kV motors), after only 1 test of the system. and nearly did it again to the next ESC. It was causing the Rx to "brown-out" I suspect - as when the camera was plugged in the "all powered up" LED stopped glowing.
After looking at the specs on the camera (2.9-5.5V Power with 215mA draw) compared with the reciever, 5V 36-48 mA I think I might have the culprit. Except... I had an EF-01 with a 360mA draw hooked in the same way and never had an issue...
I used the setup today without the camera and had no overheating issues.
What gives?