• This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn more.

Esc cuts in the right position

#1
Hello,

I have emax simonk 30A esc and A2212/13T 1000KV MOTORS.

I checked data from receiver and checked data from naze32 and the signal from both devices are correct - naze32 send correct data but motors stop when 1754. My esc cut off motors but I do not understand how to fix it. When I try to calibrate them (esc) no beeps from motors when 2000 .

It is not because of li-po because my emax simonk 30A spinn from USB only too and motors stop too.

I do not find this issue when motor is spinning directly from receiver.

Tks!

John.