In the final stretch of build number one. Have a question.
All 4 ESCs are connected to the Flip 1.5 flight controller.
ESCs are:
F-20A Fire Red series SimonK-(RapidESC)
http://witespyquad.gostorego.com/sp...mal-esc-with-rapidesc-fw-for-multirotor.html\
How do I get power to the flip 1.5 (Where do I make the connection).
Also the receive is a FRSKY X8R. The instructions for the flip 1.5 says connect:
D2 from the flight controller to Throttle/SPPM
D4 from the flight controller to Roll
D5 from the Flight controller to Pitch
D6 from the Flight controller to Yaw
The FrSky X8R has ports numbered. 1-8
Was thinking to run
D2 to port1 on RX (full cable with power)
D4 to port 2 on Rx (signal only)
D5 to port 3 on RX (signal only)
D6 to port 4 on RX (signal only)
Does this sound correct?
All 4 ESCs are connected to the Flip 1.5 flight controller.
ESCs are:
F-20A Fire Red series SimonK-(RapidESC)
http://witespyquad.gostorego.com/sp...mal-esc-with-rapidesc-fw-for-multirotor.html\
How do I get power to the flip 1.5 (Where do I make the connection).
Also the receive is a FRSKY X8R. The instructions for the flip 1.5 says connect:
D2 from the flight controller to Throttle/SPPM
D4 from the flight controller to Roll
D5 from the Flight controller to Pitch
D6 from the Flight controller to Yaw
The FrSky X8R has ports numbered. 1-8
Was thinking to run
D2 to port1 on RX (full cable with power)
D4 to port 2 on Rx (signal only)
D5 to port 3 on RX (signal only)
D6 to port 4 on RX (signal only)
Does this sound correct?