jpot1
Elite member
Just about done, gotta reinforce the center wing mount a bit. i removed the paper on the inside top of wings and then just folded the wing over the spar giving it a smoother then normal FT airfoil. Any guess on engine angle? Or how to connect the upper and lower ailerons? First biplane built or flown im pretty excited. I think you did really good Jpot! once i work out any kinks, im gonna make another one using the Christian Eagle livery. I think i read that the c pack was plenty, so landing gear shouldnt be a problem. Where and which wing is the COG
@miraspen that looks great! Yes, I did the same with the foldover wing. I like the smooth look vs. the typical FT score/fold. I used the same angle as I have been for other FT designs. I don't have the degrees, but two small washers under the top screw and two under the left giving it down/right angle. Probably around 2-3 degrees of each. C pack is perfect.
I measure the CG at ~1" back on the lower wing (measured from the front where the fuse/wing meet. Its easiest to balance this upside down.
I only used ailerons on the lower wing but I think another control horn or piece of popsicle stick extending out from the top wing with a piece of music wire between would connect the top aileron just fine.
Good luck!