Help, NAZE32 rev6 Serial Receiver bound but not receiving

[M1s3ry]

Hello, this is my 3rd quad build and first time using Cleanflight. I am not showing any stick input received by the receiver when viewing it in Cleanflight. I went through all of the settings as the manual indicated. The receiver is bound to the transmitter. I have the satellite wired to the board at the 3 wire plug. I have the UART2 port set as serial rx. Under the receiver settings I have TAER1234 as the channel map, RX_SERIAL as the mode & SPEKTRUM2048 as the receiver.

TX - Spektrum DX6i
RX - Spektrum SPM4648 serial receiver
FC - Spektrum NAZE32 rev6
Spektrum power board

Any help would be greatly appreciated. Thank you.