Help, NAZE32 rev6 Serial Receiver bound but not receiving

[M1s3ry]

Hello, this is my 3rd quad build and first time using Cleanflight. I am not showing any stick input received by the receiver when viewing it in Cleanflight. I went through all of the settings as the manual indicated. The receiver is bound to the transmitter. I have the satellite wired to the board at the 3 wire plug. I have the UART2 port set as serial rx. Under the receiver settings I have TAER1234 as the channel map, RX_SERIAL as the mode & SPEKTRUM2048 as the receiver.

• TX - Spektrum DX6i
• RX - Spektrum SPM4648 serial receiver
• FC - Spektrum NAZE32 rev6
• Spektrum power board

Any help would be greatly appreciated. Thank you.

 

[ElectriSean]

Where on the Naze is the Rx wired to? The SpekSat area or is the signal wire on pin 1? I've never seen of a spektrum branded naze, so I'm not sure what they look like.

 

[M1s3ry]

This is from the instruction sheet.

 

[makattack]

Here's the manual, but it seems to be incomplete:

https://www.spektrumrc.com/ProdInfo/Files/SPMFC3206-Manual-MULTI.pdf

The info on the RX is light too: https://www.spektrumrc.com/ProdInfo/Files/SPM4648-Manual-EN.pdf

Very strange. The RX says it supports satellite and SRXL which I assume it autodetects based on the port you connect to. Did you try Spektrum1024 as well?

 

[M1s3ry]

Thanks for the reply makattack. Those are the manuals that came with the gear & you are correct, vague at best. I did try every combo possible in Cleanflight under the receiver settings. I was beginning to question the transmitter. I connected to one of my other quads and it is working properly.