So I received a TBS Crossfire setup as a holiday gift, and I'm excited to get it installed, but I've run into a bit of a problem with the Rx to FC wiring.
My Flight controller has the pins installed as I like to swap out Receivers and such, and I don't like to solder components unless it's permanent.
The pins on the Crossfire are not the standard servo connection pins, they are much smaller with smaller wires. I only need the Gnd, 5v, CH1, and CH2. (For CSRF)
They supply a cable as shown in the image below that makes use of these 4 connections, but on the other end, they won't hook into the FC's servo style pins.
My initial thought was to cut the end, and attach a servo lead to the end, but I don't know if these wires are thick enough for that, or if that would even work.
So I guess my question is, what should I do here?
My Flight controller has the pins installed as I like to swap out Receivers and such, and I don't like to solder components unless it's permanent.
The pins on the Crossfire are not the standard servo connection pins, they are much smaller with smaller wires. I only need the Gnd, 5v, CH1, and CH2. (For CSRF)
They supply a cable as shown in the image below that makes use of these 4 connections, but on the other end, they won't hook into the FC's servo style pins.
My initial thought was to cut the end, and attach a servo lead to the end, but I don't know if these wires are thick enough for that, or if that would even work.
So I guess my question is, what should I do here?