I made accurate 3D files for the motor pod:


New member
I wanted to print a new power pod because the holes for the skewers tend to widen after nose impacts or even prop strikes from landing.
I noticed the versions of the swappable power pod on thingiverse didn't seem to incorporate the angle offset for the motor.
So I pulled up the free plans for the FT Trainer and traced the motor pod exactly. (Flite test is amazing for providing free plans)

Anyways, here is the thingiverse page for it (Bonus: this is my first thing on thingiverse)


ps-i know the one in the picture is mirrored. I fixed that after I noticed it and printed another one. It's correct in the stl file.


  • da9e53e8bb5b301084b8361c22552698.jpg
    352.6 KB · Views: 0