stuart1960
New member
Hi, im A newbie with a problem. i have a Lumenier Lux V2 that was working ok. After flashing new firmware to a Frsky internal moduel and a XM plus receiver while connected to the flight controller i suddenly got a different led sequence on the board. It started doing three fast flashes of red and green followed by two long flashes repeatedly. When i connect to my computer it now says usb device not recognised. If i connect in bootloader mode this doesnt happen and it connect to betafligh. It shows up in betaflight as DFU and i can flash to the board. but that is all i can do. if i try to get to set up it says it failed to connect. What has happened and what do the light sequence mean. Any help would be greatly appreciated