Awsome_Chicken
Junior Member
******Solved******
I have built my first quadcopter earlier this year and it had been working fine until an ESC died, not knowing if the others would die I purchased a 4-in-1 ESC, the Q Brain 4x20A. so yesterday I got that all mounted and wired up, the motors were spinning the correct directions, but today when I took it out to fly I couldn't get it off the ground. Whenever I tried it would roll over back into the ground. so I re-calibrated the ESC, no change. I re-flashed base flight onto my Naze32, no change. So I flashed to Cleanflight, no Change. Now at about 4:00 pm (and several sets of props later), I have tweaked every setting I could and no change. Has anyone ever had this problem before or a suggestion of what might be wrong? All help is appreciated.
I have built my first quadcopter earlier this year and it had been working fine until an ESC died, not knowing if the others would die I purchased a 4-in-1 ESC, the Q Brain 4x20A. so yesterday I got that all mounted and wired up, the motors were spinning the correct directions, but today when I took it out to fly I couldn't get it off the ground. Whenever I tried it would roll over back into the ground. so I re-calibrated the ESC, no change. I re-flashed base flight onto my Naze32, no change. So I flashed to Cleanflight, no Change. Now at about 4:00 pm (and several sets of props later), I have tweaked every setting I could and no change. Has anyone ever had this problem before or a suggestion of what might be wrong? All help is appreciated.
Last edited: