Did a Quadcopter scratch build which I designed the entire frame and 3D printed it and assembled. Looking at thrust data for motors I went with 2208's and am running 6045 tri-props on it (data says ~800g thrust). The frame size itself is about 350-400mm, and I have flown it a few times with good results. I was wondering what differences in flight I would notice by putting 2216 motors with 1045 propellers on it (data says ~1000g thrust). I am looking to this as I see it would be more efficient and I would expect longer flights. Thoughts? what other things would I notice doing this? would you advise doing this? and why? Reading says that it would be more susceptible to wind, is that true? Also would this be less responsive in thrust, therefore not drop as fast when i decrease throttle? Just looking for advice here, thank you!!