DesertFerg72
Junior Member
Just got done building and installing aluminum motor mount.
Made 3 mounts, 2", 3", & 4" widths. Installed the 4", with nylon bolts and a little hot glue
Scratch Build Pusher Motor Mount
- Thread starter DesertFerg72
- Start date
Just got done building and installing aluminum motor mount.
Made 3 mounts, 2", 3", & 4" widths. Installed the 4", with nylon bolts and a little hot glue
ProfessorFate
Active member
Hey
All this looks really nice, that motor, mount, the foam with those forms that hold the stabs,....
anhedral wingtips on a jet?...... Just guessing. And I like the flourescent green and red/orange tape colors where did you get those?
The ones I got from Tape Brothers are primary colors.
Could you show us some more pictures of the whole airplane? What is it?
Thank you
Leonard
All this looks really nice, that motor, mount, the foam with those forms that hold the stabs,....
anhedral wingtips on a jet?...... Just guessing. And I like the flourescent green and red/orange tape colors where did you get those?
The ones I got from Tape Brothers are primary colors.
Could you show us some more pictures of the whole airplane? What is it?
Thank you
Leonard
Last edited:
DesertFerg72
Junior Member
foam board insulation & tape from Home Depot
