Swapable power pod question

[Liemavick]

Hello all, Im a bit confused which isnt hard to do since Im still new to the foam builds. I'm currently building the Old Fogey and followed Josh B's build video. At the begining he says to build the power pod and points to a video link that pops up in the video. I opened the link and it showed the assembly of it for another plane. Long story short is I found the pDF for that pod and built it. I got far enough along on the Old Fogey build to install the power pod and it doesn't seem to be the right design. I went back to Josh's build video and the one he installs is different then the one the video had me build. Anyone have a link to the PDF for the Old Fogey pod or did I mess up? Pics below

Thanks,
Brian

 

[rwhitlow]

Here's the article.

http://www.flitetest.com/articles/ft-swappable-power-pod-kit

 

[Liemavick]

Thanks Rich. i just printed them out and see what I did wrong. When I taped the plans together last night I must of inverted the one middle section which put the tab close to the front instead of the middle where it should be. Round two later today.
thanks again!

Brian