Hello there,
I am working on a project to build a VTOL tandem wing model with distribution propulsion system. The front wing has four motors and two elevons, and the rear wing has the same configuration.
I have been trying to configure this in arduplane, but I am not sure how to do it. I read the documentation and I found out that the best mode for this is a tailsitter.
However, I am still confused about how to assign the servo and motor functions.
I would appreciate it if someone could help me with this.
Thank you.
Reference models.
Model 1
Model 2
I am working on a project to build a VTOL tandem wing model with distribution propulsion system. The front wing has four motors and two elevons, and the rear wing has the same configuration.
I have been trying to configure this in arduplane, but I am not sure how to do it. I read the documentation and I found out that the best mode for this is a tailsitter.
However, I am still confused about how to assign the servo and motor functions.
I would appreciate it if someone could help me with this.
Thank you.
Reference models.
Model 1
Model 2
