jack10525
Active member
Hello,
I am starting to build a versacopter. I found a complete v2 kit with a thin naze 32 fc. This fc comes with pre-soldered connectors and plugs. During my build I am following the FT video for the naze. They start out soldering 2 connectors on to the board(which I don't need to do). Once that is done they proceed to flash the fc. Again I'm not able to do this. When I plug in my board I do not have that option. I am only able to connect with com4 and then is goes right into the setup menu. It looks like the fc is already configured.
I am starting to build a versacopter. I found a complete v2 kit with a thin naze 32 fc. This fc comes with pre-soldered connectors and plugs. During my build I am following the FT video for the naze. They start out soldering 2 connectors on to the board(which I don't need to do). Once that is done they proceed to flash the fc. Again I'm not able to do this. When I plug in my board I do not have that option. I am only able to connect with com4 and then is goes right into the setup menu. It looks like the fc is already configured.