rallekralle11
Actually not a bad flyer
Hey everyone.
I've started building a tricopter for arial fotography based on the rcexplorer v2,5 design.
So i'm wondering if there's anything especially important i should remember before buying electronics and putting it all together. (it's my very first multirotor)
Or if there is anything that could make it easier, better, simpler.
electronics i plan on buying:
KK 2.1.5 control board
or maybe something available in the EU warehouse
hxt DT750 750kv motors
turnigy 18amp plush ESC's w/ programming card
turnigy 2.2 3s 25c battery
Corona 12,5g digital mg servo
Orx R710 receiver
10x4,7 GWS props
Basically the stuff David recommends, but i'll just put it here anyway
progress so far:
thanks. -ralle
I've started building a tricopter for arial fotography based on the rcexplorer v2,5 design.
So i'm wondering if there's anything especially important i should remember before buying electronics and putting it all together. (it's my very first multirotor)
Or if there is anything that could make it easier, better, simpler.
electronics i plan on buying:
KK 2.1.5 control board
or maybe something available in the EU warehouse
hxt DT750 750kv motors
turnigy 18amp plush ESC's w/ programming card
turnigy 2.2 3s 25c battery
Corona 12,5g digital mg servo
Orx R710 receiver
10x4,7 GWS props
Basically the stuff David recommends, but i'll just put it here anyway
progress so far:
thanks. -ralle
Last edited: