Rasterize Thunderbird Skins for Ben Harber's (Mid7night) F16 1

[Rasterize]

Rasterize submitted a new resource:

Thunderbird Skins for Ben Harber's F16 - Thunderbird Skins for Ben Harber's F16 24X36 Page size

Ben Harber F16 Thunderbird Skins. As seen at Flite Fest Ohio 2018.
This skin was create as a "thank you" to Dan "Sp0nz" Sponholz for all his work on producing FT plans. Thanks Dan! The pilot name has been changed to Lt. Col. Kevin Walsh, current Commander/Leader and pilot of #1. Dan's plane also covered with a clear shelf liner which added to its durability but the added weight did not seem to degrade performance to much.
The PDF is set to print on an Arch D size paper - 36" x 24" If you...

Read more about this resource...

 

[thenated0g]

Rasterize submitted a new resource:

Thunderbird Skins for Ben Harder's F16 - Thunderbird Skins for Ben Harder's F16 24X36 Page size



Read more about this resource...

Do you recommend a tutorial for applying these? I havent ever seen it done before. Thanks.

 

[Marshall_S]

Rasterize submitted a new resource:

Thunderbird Skins for Ben Harber's F16 - Thunderbird Skins for Ben Harber's F16 24X36 Page size



Read more about this resource...

What is the best type of paper to print the skins on?

 

[Rasterize]

The lighter the better. Also uncoated. Coating just adds weight. I usually go for a 20lbs bond uncoated. Cheap and available. Takes glue better as well. FyI let glue dry completely before spraying any kind of polycylic. Otherwise the poly can interfere with adhesion.

 

[Marshall_S]

The lighter the better. Also uncoated. Coating just adds weight. I usually go for a 20lbs bond uncoated. Cheap and available. Takes glue better as well. FyI let glue dry completely before spraying any kind of polycylic. Otherwise the poly can interfere with adhesion.

Thanks for the prompt reply. Will these fit the Flite Test Limited F-16 Viper?