Rasterize Thunderbird Skins for Ben Harber's (Mid7night) F16

Rasterize Thunderbird Skins for Ben Harber's (Mid7night) F16 1

Please log in to download

Rasterize

Maker of skins and decals for foam board RC planes
Moderator
Mentor
Rasterize submitted a new resource:

Thunderbird Skins for Ben Harber's F16 - Thunderbird Skins for Ben Harber's F16 24X36 Page size

Ben Harber F16 Thunderbird Skins. As seen at Flite Fest Ohio 2018.
This skin was create as a "thank you" to Dan "Sp0nz" Sponholz for all his work on producing FT plans. Thanks Dan! The pilot name has been changed to Lt. Col. Kevin Walsh, current Commander/Leader and pilot of #1. Dan's plane also covered with a clear shelf liner which added to its durability but the added weight did not seem to degrade performance to much.
The PDF is set to print on an Arch D size paper - 36" x 24" If you...

Read more about this resource...
 
Last edited:

Rasterize

Maker of skins and decals for foam board RC planes
Moderator
Mentor
The lighter the better. Also uncoated. Coating just adds weight. I usually go for a 20lbs bond uncoated. Cheap and available. Takes glue better as well. FyI let glue dry completely before spraying any kind of polycylic. Otherwise the poly can interfere with adhesion.
 

Marshall_S

New member
The lighter the better. Also uncoated. Coating just adds weight. I usually go for a 20lbs bond uncoated. Cheap and available. Takes glue better as well. FyI let glue dry completely before spraying any kind of polycylic. Otherwise the poly can interfere with adhesion.
Thanks for the prompt reply. Will these fit the Flite Test Limited F-16 Viper?