Longbaorder23
Senior Member
Hey all,
I just got my Frsky system in yesterday, and i had the chance to test it today in the wonderful weather. however, twice today, i experienced some problems. Range on the Frsky was fantastic, passed the range test with flying colors. however, during flights today, i experienced towards the end of the flights, if that means anything, but i experienced the model going into failsafe right in the middle of a maneuver. I thought, some people say the power switch on the 9x is bad, but its not. my transmitter had no issues, no shut downs, no loss of electrical contact, nothing. Ive decided its a receiver issue. now im using a non telemetry receiver, and its HV.... not sure if that has anything to do with it... but im using it in a foamie 3D plane on 3s lipo. ive heard this is the common scenario when a brownout occurs. but my model goes into failsafe. is this still a brownout? Also, I understand that the BEC in my ESC isnt the best for this situation, high travel servos, large control surfaces, and lots of jerky fast movement. Since my receiver is HV though... could i simply wire the 3s lipo BALANCE lead to my reciever? Will this help my problems? i was able to save one "brown out" before it crashed because it rebooted, but the other time was way to close, i pulled up at 10 feet above the ground and barely saved it. Can i do that? will that solve my problem? Thanks!
I just got my Frsky system in yesterday, and i had the chance to test it today in the wonderful weather. however, twice today, i experienced some problems. Range on the Frsky was fantastic, passed the range test with flying colors. however, during flights today, i experienced towards the end of the flights, if that means anything, but i experienced the model going into failsafe right in the middle of a maneuver. I thought, some people say the power switch on the 9x is bad, but its not. my transmitter had no issues, no shut downs, no loss of electrical contact, nothing. Ive decided its a receiver issue. now im using a non telemetry receiver, and its HV.... not sure if that has anything to do with it... but im using it in a foamie 3D plane on 3s lipo. ive heard this is the common scenario when a brownout occurs. but my model goes into failsafe. is this still a brownout? Also, I understand that the BEC in my ESC isnt the best for this situation, high travel servos, large control surfaces, and lots of jerky fast movement. Since my receiver is HV though... could i simply wire the 3s lipo BALANCE lead to my reciever? Will this help my problems? i was able to save one "brown out" before it crashed because it rebooted, but the other time was way to close, i pulled up at 10 feet above the ground and barely saved it. Can i do that? will that solve my problem? Thanks!