Capt_Beavis
Posted a thousand or more times
I "Capt Beavis" cut out a design for one of those crazy 2 dimensional 3D planes like the AS3Xtra.
I have two questions.
1. My measurements for the wings and tail portion were off a bit. Will there be issues if the tail extends past the rudder (I know I need clearance for the rudder)? Or should I redo it?
2. What should I look for to find the lightest motor, ESC, Rx and servos?
I just did this because I had the foam board and it seems like an easy thing to cut out. Plus I am on vacation and though I am flying with my kids 3x a day I can't do it every minute.
I have two questions.
1. My measurements for the wings and tail portion were off a bit. Will there be issues if the tail extends past the rudder (I know I need clearance for the rudder)? Or should I redo it?
2. What should I look for to find the lightest motor, ESC, Rx and servos?
I just did this because I had the foam board and it seems like an easy thing to cut out. Plus I am on vacation and though I am flying with my kids 3x a day I can't do it every minute.